SPA FROG SPA CARE GUIDE

Spa FROG® products use a patented EPA approved mineral formula, Fresh Mineral Water™, along with a low dose of chlorine leaving your spa water cleaner, clearer, and softer; without the hassle of measuring out and touching chemicals.

Please keep this guide in a safe place so you can easily find it for questions that arise in the future. If you need additional help, please call our spa Customer Service team seven days a week at 844-853-4235 or visit www.spaheadquarters.com.
 
ABOUT YOUR SPA FROG PRODUCTS

SPA FROG IN-LINE SYSTEM

The Spa FROG In-Line System is made up of:

A: FROG cap that is distinguishable among the fittings on the top of the spa.

B: Cartridge holder that pulls out of the system.

C: Mineral cartridge that helps control bacteria in water.

D: Bromine cartridge that helps support the minerals while oxidizing contaminants like body oils. The cartridges are adjustbable to meet your specific spa water needs.

image-1
BENEFITS OF SPA FROG PRODUCTS

Spa FROG In-Line System allows you to enjoy your spa more with less work and less bromine than other spa chemicals!

You’ll experience LESS WORK because:
  1. FROG Mineral System continuously works to control bacteria for up to 4 MONTHS.
  2. Cartridges last longer to eliminate daily maintenance.
  3. Cartridges are pre-filled for no measuring or mess.
  4. Simply adjust to your setting and relax for weeks.
You’ll experience LESS BROMINE because:
  1. With minerals in the water, bromine use is cut by up to 50%.
  2. Bromine last longer: 2-4 weeks on a 350 gallon spa with average use.
  3. Water feels softer & system leaves water crystal clear.
  4. FROG Mineral System works with bromine.
 

REPLACING CARTRIDGES

Step 1: Open cap of Spa FROG In-Line System. Then, set cap aside. Note: Do not open cap while jets are on.

Step 2: Remove holder and spent cartridges. Push down holder and turn counterclockwise before pulling out. Push bottom out through openings in back of holder. Then grab cartridges and pull out.

Step 3: Snap in new cartridges. Spa FROG Mineral Cartridge snaps into the area marked “minerals” (top), & the Spa FROG Bromine Cartridge snaps into the area marked “bromine’ (bottom). Line up the indentation at the top of cartridges with raised area of holder.

Step 4: Insert holder in system (slowly!) Line up holder arrow with system arrow. Push down until holder tabs go past system tabs, and turn holder right (clockwise) until it stops. You can ensure it’s locked by attempting to pull the holder up. If it stays put, its secure.

Step 5: Begin regular spa care as soon as start-up is complete.

THE IDEAL WATER BALANCE

TESTIDEAL RANGEASSOCIATED PRODUCT
pH 7.2 - 8.2 PPM AquaCheck Trutest, AquaCheck 6-in-1
Total Alkalinkity 80 - 150 PPM AquaCheck Trutest, AquaCheck 6-in-1
Calcium Hardness 150 - 250 PPM AquaCheck 6-in-1, AquaCheck Trutest
Chlorine & Bromine 3.0 - 5.0 PPM AquaChek Chlorine, AquaChek Bromine, AquaCheck Trutest

START-UP

Step 1: Follow all directions from your spa manufacturer on filling and balancing spa water.

Step 2: Use a metal out or sequestering agent if water is high in metals. Wait 24 hours to finish setting up.

IMPORTANT NOTE: Before using cartridges, establish initial residual of 1.0-2.0ppm bromine or chlorine. Don’t use a non-chlorine shock. Do NOT add it through the Spa FROG In-line System. For best results use the Spa FROG Jump Start that quickly dissolves with a fizzing action. Use one packet per 500 gallons.

Step 3: Use Spa FROG Brand Test Strips. Test Strips accurately maintain the bromine level following the directions carefully.

Step 4: Set Mineral and Bromine cartridges. When the spa reaches operating temperature, set cartridges according to directions and insert them into system.

 
 
 

IMPORTANT SPA FROG PROCEDURES

PRODUCT SAFETY TIPS

CLEAN YOUR FILTERS: Spa Frog’s products rely heavily on filtration. Regular and proper cleaning of the spa’s filters using a product such as Spa FROG In-Line System are pivotal to the success of using the product

MAINTAIN WATER LEVEL: Water should be at least 7 1/2 centimeters (3 inches) above filter intake. Low water levels will lead to cloudy water.

SHOCK SPA ONCE A WEEK: Shock with granular chlorine or on chlorine shock. Additional shocking may be required if spa is under heavy use. This happens when the spa is new.

REPLACE CARTRIDGES: Replace the Spa FROG Mineral Cartridge at least every 4 months. Do not attempt to reuse the product.

Copyright © 2016 SpaHeadquarters.com. All rights reserved.